Clone A Willy Kit Penis Molding Set DIY Hens Couples Glow Green Vibrator Dildo

Original Empire Labs Clone-A-Willy Penis Casting Kit Glow in the Dark

Includes everything needed to make an exact vibrating replica of your favourite penis.

The Clone-A-Willy’s medically tested moulding gel process captures incredible, life-like detail, making this the most personalised vibrator you will ever own. 

This kit lets you make an exact silicone replica of any penis, safely and easily in the comfort of your own home. 

It's fun and easy to do!

Each kit contains the following:

·         1x Molding Tube (2.5” wide, 11” tall) part of outer packaging

·         2x Silicone Tubs (one colour, one clear)

·         1x Bag of Algae Based Moulding Powder

·         1x Single Speed Vibrator Unit

·         1x Stirring wooden stick

·         1x Thermometer

·         1x Full instructions

Extremely important to read the whole instructions carefully before you start the process.

If you make a mistake with the molding powder then you can purchase extra powder.

If your penis is longer than 9” then you will need extra molding powder and extra silicone which you can purchase separately. If you don’t want to use the vibrating unit then you will need extra silicone.

This item is sold as an Adult Novelty no claims are made regarding it.
All information is supplied by the manufacturer.

How to use the Clone-A-Willy Penis Molding Kit

1^st Starting with an erect penis, hold the permanently sealed end of the tube against your body and mark where your penis reaches on the tube, then cut the tube to size by removing the excess. (Since the edge you just cut will be pressed against your body later, we recommend wrapping some tape over any jagged cuts so the tube feels smooth and comfortable against your skin.)

The following 2 steps are temperature-dependent, so make sure you’ve read the instructions and you’re ready to work quickly!

2^nd Heat some water to exactly 32°C, then pour 415ml (or 1 and ¾ cups) of it into a large mixing bowl. Set a timer for 2 minutes, then immediately pour the bag of moulding powder into the water and start mixing, stirring for no longer than 60 seconds — it’s normal for the mixture to still be a bit lumpy at this stage.

3^rd Pour all of the mixture into the moulding tube, then insert your erect penis into the tube while pressing it firmly against your body. There may be some spillage, so we advise you use your Clone-A-Willy moulding kit in the kitchen, bathroom, or with a tarp down. Your penis must be inside the tube before your 2-minute timer is over, otherwise the moulding powder will set before you get a chance to shape it.

4^th If your penis is touching the side of the tube, rotate or angle it for a more central placement. Wait a few minutes for the mould to solidify, then gently remove your penis from the tube and leave your new penis mould to air-dry for at least 2 hours.

5^th Empty the two jars of liquid silicone into a clean, disposable container. Use the included stir stick to get as much of each liquid out as possible, then stir them together for at least 2 minutes before pouring into the moulding tube until it’s about an inch (2.5cm) from the top.

6^th If you want to add the included vibrator to your DIY dildo, make an X-shaped cut in a small cardboard square, then push the vibrator tip-first through the X until the cardboard is sitting just above the control dial. Insert the vibrator tip-first into the silicone until the cardboard hits the lip of the tube, making sure it doesn’t touch the sides of the mould, then leave to set for 24 hours. After 24 hours, check to see if the silicone has fully cured, then remove your new DIY dildo from the moulding tube and enjoy!